Ameriphone Wake Assure Alarm Clock Instructions

1. Press and hold the CLOCK button down.

2. Push the HOUR button until the desired hour [AM or PM] appears on the display panel.

3. Repeat Step 2 using the MINUTE button to set desired minute.

1. Press and hold the ALARM button down.

2. Push the HOUR and then the MINUTE button until the desired wake up time appears on the display panel.

1. Slide the MODE switch to the Audio or Lamp or Bedshaker or ALL position.

2. Slide the ALARM switch to the ON or the AUTO SNOOZE position. If auto snooze is selected, the alarm will go off every 5 minutes for the next 60 minutes. To interrupt the alarm momentarily, press the SNOOZE/ RESET button. To shut off the alarm and stop auto snooze completely, slide AUTO SNOOZE to the OFF position.

1. Slide the switch to the ON position. The connected lamp will come on and off for a few seconds at a time at random times between 6PM and 11PM to simulate as if someone is in the house.

2. To cancel the TIMER after it has come on, press the SNOOZE/ RESET button once. Press the button again to operate the lamp. The TIMER will come on again the next day.

3. To turn the timer OFF permanently, slide the switch to the OFF position.

A 9-volt battery can be installed to retain time and the programming of the alarm settings in case of a power outage. When the power comes back on, the clock's previous time and alarm settings will be still be operational. During a power outage, the clock will not display the current time and all its alarm functions will not be operational. Be sure to plug the unit in before installing batteries. Failure to do this could cause the time to be slow by four hours per day outside the United States and Canada. If this problem occurs, unplug the unit and remove the batteries. Then plug the unit in before installing batteries. Please observe caution when handling electrical appliances.