247511 Sonic Alert Travel Clock with Bedshaker Instructions

1) Press and hold the TIME button (6) at the same time press the HOUR button (9) to advance the clock display rapidly until the hour is correct.

2) Press and hold the TIME button (6) at the same time press the MIN button (10) to advance the minute until the correct time is shown.

3) A lighted dot (2) in the upper left of clock display indicates time is PM. For AM time indication, there is no lighted dot.

1) Simply follow the instructions mentioned under " Setting the correct time" except that you will have to press the AL set button (5) instead of the TIME button.

2) Make sure the alarm time is correctly set for AM or PM, lighted dot (2) indicates PM. Be sure to release the HOUR and MIN set buttons before releasing the ALARM button.

SNOOZE button (3) press after alarm has sounded. The alarm will be turned off for 9 minutes for extra sleep. The alarm will come back again after 9 minutes. You may repeat this cycle many times up to 59 minutes maximum.

Set the alarm time you wish and slide the VIB / BUZZ, VIB, BUZZ, OFF (8) switch to the desired position. VIB / BUZZ for both vibrator & sound, or VIB for vibrator only or BUZZ for sound only. To turn alarm off select the OFF position.

Adjust the tone (11) by rotating the tone wheel located at the top right-hand side. Adjust from left to right for desired tone pitch.

To adjust the volume (4) rotate the wheel located on the front right hand side bottom corner. The higher the number the louder the volume.

1) Attach the bed shaker input jack to the back of clock at VIBRATOR input.

2) To set vibrator for alarm slide switch (8) to desired position.

3) Put vibrator under mattress or pillow.

Attach the AC power supply input to the back of clock at AC-9V IN next to the VIBRATOR input.

To use battery backup, you can install a 9-volt alkaline battery in the back of the clock. Located under the left side slide the battery access cover to the left and install battery. Battery not included.

Power: 110 Volts, Consumption 8 watts, 60Hz
UL listed transformer (Underwriters Laboratories)